User Tools

Site Tools


triangle:triangle

Parametric Triangle Loop Design

The Triangle Loop or Delta Loop is type of loop antenna that can be build in the VHF/UHF/SHF range. General information can be found on wikipedia:

Loop antenna

I was insprired by an article in the April issue Electron 2026 by Eddy Cretier - PA0EHC about a Triangle Loop antenna for the 70 cm HAM radio band.. He scaled the 2m design by W4RQ to 70 cm. The design of the “Horizontally Polarized Two-Meter Triangle Loop Antenna” can be found here:

W4RQ article in QEX 2023

See the most recent 3D designs here:
Parametric Triangle loop design

The orginal article describes an antenna build from an aluminium ruler strip and common materials. The main reason to build this antenna was the horizontal polarisation. Antennas can be inverse proportional with the frequency. The off the shelf size of materials is a practical limitiation. Using 3D printing the size is flexible, the surface metalized can we made with thick professional aluminium tape.

The illustrations from the W4RQ 2m build show the simple construction.
The 70cm dimensions do fit in my 3D printer, incluiding a mast mount. In the 868 ISM band where vertical polarisation is common, we can create extra “room” by using horizontal as well. Because my most recent antenna builds focus on both 23 and 21 cm I started with a miniature 1420MHz version.
I wrote a generic OpenSCAD script to calculate and did build some prototypes:

Both antenna's did tune very easily and the calculated loop wire length did not need much tuning.For the 70cm model the loop can be tuned with a M3 brass screw. In the 1420 MHz I used 0.8 mm silverplated hooby wire for the loop, tuning is possible thanks to the a cylidrical contact I harvested from a female header strip. See the LiteVNA readings below:

triangle/triangle.txt · Last modified: by pe1bmc-self